Audi Check Engine Light On?

Common Causes For Audi Check Engine Light

Has the check engine light turned on in your Audi? It can be alarming seeing an engine warning appear on your dashboard, especially if you've never seen it before. A wide array of issues can cause a check engine light to come on, some more serious than others. Fortunately, Audi Owings Mills is here to help you figure out what might be wrong and what your next steps should be. Below we have highlighted the most common causes of a check engine light.

  • Loose Gas Cap: Your gas cap is loose, broken, or simply missing. Gas cap issues can reduce fuel pressure and allow fuel vapors to escape, reducing fuel economy and increasing harmful emissions.
  • Failing Catalytic Converter: Your catalytic converter can eventually clog with material, especially with higher mileage vehicles. The catalytic converter is a vital part of the emissions system, removing toxic carbon monoxide. A failing or clogged catalytic converter can severely impact fuel economy and vehicle performance.
  • Fouled Spark Plugs or Spark Plug Wires: Over time, you will eventually need new spark plugs or spark plug wires. Your spark plugs create a hot spark that ignites the air-and-fuel mixture in the cylinder, allowing your engine to start and run. Faulty spark plugs or spark plug wires can cause your engine to misfire, reducing fuel economy and performance and even preventing it from running altogether.
  • Faulty Oxygen Sensor: Your oxygen sensor might need replacing due to prolonged exposure to hot exhaust gas. The oxygen sensor provides vital air-fuel mixture information to the ECU. A faulty oxygen sensor can cause your vehicle's computer to supply the engine with too much or too little fuel. An engine with too little fuel is at risk of total engine failure, and an engine with too much fuel will create excessive smoke and odor.
  • Faulty Mass Air Flow Sensor: When exposed to dirty or particle-rich air, the Mass Air Flow (MAF) sensor could fail. Like the oxygen sensors, the MAF sensor measures the amount of air entering the engine and helps ensure the proper air-fuel mixture. A faulty MAF sensor can cause your engine to misfire, ultimately causing poor fuel economy, performance and potentially more unnecessary damage to your engine.

What to Do if Your Audi Check Engine Light Comes On

No matter the situation, when the check engine light comes on in your Audi, we always suggest stopping by our service center so one of our knowledgeable technicians can properly diagnose and repair your vehicle. Our service technicians have the most up-to-date diagnostic equipment that can quickly read Audi OBD-II Trouble Codes.

The way your check engine light is behaving can help you determine what might be wrong with your Audi and the severity of the issue. To help you better understand what you should do next, we've outlined possible scenarios:

  • The check engine light only comes on in certain conditions: If the check engine light is coming on intermittently, be sure to notice any changes in the performance of your vehicle when the light is on. If you do notice a difference, try driving your vehicle as little as possible until you can bring it in for service. Most likely, something is on the verge of failing, and you run this risk of your vehicle not starting again.
  • The check engine light is constantly on: Your vehicle's onboard diagnostic system has determined something is wrong and needs to be fixed. Although your vehicle may seem to be operating fine, it's best to bring it in for service as soon as possible to prevent additional issues.
  • The check engine light is on, and there is a noticeable performance issue: If you are noticing a consistent decrease in performance with the check engine light on, your vehicle may have automatically entered a "limp-mode" to prevent additional damage. In this case, you should come straight to our service center or have the vehicle towed to prevent any damage to the engine.
  • The check engine light is blinking while driving: Not to be confused with the light occasionally flickering in the first situation, if your check engine light is blinking consistently, that typically indicates there is a major issue with your vehicle, and you should pull over when safe. If you are not close to our service center, we suggest having your vehicle towed here to be safe.

If you any additional questions regarding check engine lights, please give us a call at 410-497-6235 to speak with one of our teammates, or simply schedule an appointment with our online form.

  1. Audi Owings Mills

    9804 Reisterstown Road
    Owings Mills, MD 21117

    • Sales: 410-497-6235
Loading Map...

Get in Touch

  • Contact our Service Center at: 410-497-6257
  • Monday7:30AM-6:00PM
  • Tuesday7:30AM-6:00PM
  • Wednesday7:30AM-6:00PM
  • Thursday7:30AM-6:00PM
  • Friday7:30AM-6:00PM
  • Saturday8:00AM-4:00PM
  • SundayClosed